D3 must be restarted to put UNIX in multiuser mode.
To restart the virtual machine:
Shut down the D3 system. Enter:
|
shutdown |
The following prompt displays:
|
Shutting down "pick0:LINUX" Do you wish to continue (Y/N/0)?_ |
Enter y.
Wait for the Flush complete message to display. It may display before or after the virtual machine halted message.
|
Flushing memory, boot when disk is quiescent... Wait for...Flush complete... Flush complete. Virtual machine pick0:LINUX halted. Disconnected from Virtual Machine 'pick0:LINUX' |
The D3 virtual machine has been halted.
Put UNIX into multiuser mode.
Depending on specific site requirements, this may be run-level 2, 3, 4 or 5. Enter:
|
init # |
where # is the proper run-level to reboot UNIX in multiuser mode.
Log in to UNIX.
If a non-root user was specified in the pick0 configuration file during the installation, log in to this user, Creating a UNIX User Account for D3.
If the user root was specified in the pick0 configuration file during the installation, log in as root.
Restart the D3 virtual machine. Enter:
|
d3 -0 |
The following prompt displays:
|
Options: F)ile only, A)BS only, X) eXecute. Q)uit = _ |
Type X.
See Also
Installing D3 With the Chosen Settings