This section contains instructions for creating a UNIX User account for D3.
Creating a D3 UNIX User Account
When the D3 virtual machine starts up, it gives all of its processes (D3 users) the same UNIX system privileges that the virtual machine has, which may not be desirable. The D3 configuration file's user statement specifies the UNIX user account (and thus the privileges) for D3 users.
If the user statement is not present, the user and privileges for root are assumed and creating a new UNIX user is not required.
If the user statement specifies another user, this UNIX user must be created prior to booting D3.
The user name is the name specified in the Display/Modify D3 configuration menu. The user name pick is used in the instructions below.
As of Red Hat Enterprise Linux, the Linux operating system opens a screen to create a UNIX user account after the operating system has been installed. The pick user account should be created at this point by entering the username pick and password.
If the pick user account is not created after the Linux installation, it can be created later by the following steps:
Log in as root.
At the shell prompt, enter these commands and respond to the prompts appropriately:
useradd pick passwd pick |
For more information on this procedure, see your UNIX System Administration Guide.
See Also
D3 Installation Guide Overview
Upgrading with a File-Save Tape