Changing the MVSP password

Complete these instructions to change the MVSP user or account password on D3.

Note:
  • Passwords are not supported for mvBase 3.0 implementations.

  • For UNIX Only: Prior to performing these instructions, UNIX users must be logged on as root and connected to D3 using the d3 command with the -l option.

Procedure

  1. Use the password program to set the user and account passwords.
  2. In the MVSP account, open the MVSP PASSWORD utility by entering the MVSP.PASSWORD command from TCL. For example:
    :MVSP.PASSWORD
    

    The MVSP PASSWORD utility displays. Note that this message will vary slightly from the illustration below if you are running in Windows Authentication mode.

    :MVSP.PASSWORD
    (U)SER PASSWORD OR (A)CCOUNT PASSWORD OR (Q) TO QUIT ? U
    
  3. Do one of the following:
    • Enter A to change the MVSP account password.

      The following prompt displays.

      Enter the password for the MVSP Account (QUIT to abort) ?
    • Enter U to change the MVSP user password.

      The following prompt displays.

      Enter the NEW password for the MVSP user (QUIT to abort) ?
  4. Do one of the following:
    • If you are running in Windows Authentication mode, type and confirm the password for the Windows MVSP user or account.

    • If you are running under a D3 MVSP user, type and confirm the password for the D3 MVSP user or account.

    The password is changed.