phantom-reset command

The phantom-reset BASIC program resets the specified phantom lines to available status. If a UNIX process for a phantom is gone (PID 0), it recreates the process and ensures that the port on the D3 side is available to handle the next request.

No checking is done to ensure that the phantom line is actually available, so this command must be used with extreme caution only after the phantom line is known to be available.


phantom-reset {a,b{,n-m}} 

Phantom lines can be specified either one at a time (as a,b above), or in a range (as n-m above), or any combination thereof.

Warning: Do not use this command on a phantom line unless you are absolutely sure that it should be available and it is not. Making a line available when it is truly busy corrupts the scheduler and can lead to loss of data.