odbc-setup command The odbc-setup utility allows you to start, stop, and configure the ODBC server. Additionally, the current server status and version can be displayed.
off command (TCL commands) The off command stops processing at all levels on the current line and returns control to the initial logon prompt. This command is also valid from the system (virtual) debugger and the FlashBASIC debugger.
okidata command The okidata BASIC program changes characteristics on Okidata printers.
onneterror command onneterror is a globally cataloged subroutine that can be called from the FSI when a network error occurs during FlashBASIC file I/Os. This allows users to break out of the error and customize the subroutine.
op command The op command invokes the Output processor on specified items.
overflow command The overflow command displays the system overflow table which contains the addresses of available disk frames. All unused frames are available for use by the spooler, the D3 file system, and the process workspace.
ovf-monitor command The ovf-monitor command monitors and displays overflow consumption on a port by port basis.