Restarting the Virtual Machine

Complete these instructions to restart the virtual machine.

To shut down the D3 system:

To shut down the D3 system, enter:

shutdown

The system displays:

Shutting down "pick0:LINUX

Do you wish to continue (Y/N/0)?_

Enter y.

Wait for the Flush complete message to display. It may display before or after the virtual machine halted message.

Flushing memory, boot when disk is quiescent...

Disconnected from Virtual Machine 'pick0:LINUX'

Flush complete. Virtual machine pick0:LINUX halted.

The D3 virtual machine has been halted.

Put UNIX into multiuser mode.

Depending on specific site requirements, this may be run-level 2, 3, 4 or 5. Enter:

init #

where # is the proper run-level to reboot UNIX in multiuser mode.

If a non-root user was specified in the pick0 configuration file during the upgrade, then exit and log on as the correct user, otherwise stay logged in as root.

Restart the D3 virtual machine, enter:

d3 -0

The following prompt displays:

Options: F)ile only, A)BS only, X) eXecute. Q)uit = _

Type X.