D3 must be restarted to put UNIX in multiuser mode.
If AIX was upgraded as part of this installation,
and this is a turnkey system, remember to restore the /etc/inittab file.
CAUTION:
If the upgrade was
from a previous D3 or Advanced Pick release, all FlashBASIC programs
should be recompiled to ensure system integrity and performance.
Procedure
Shut down the D3 system. Enter:
shutdown
The following prompt displays:
Shutting down "pick0: AIX"
Do you wish to continue (Y/N/0)?_
Enter y.
Wait for the Flush complete message to display.
It may display before or after the virtual machine halted message.
Flushing memory, boot when disk is quiescent...
Wait for...Flush complete...
Flush complete. Virtual machine pick0: AIX halted.
Disconnected from Virtual Machine 'pick0: AIX'
The D3 virtual machine
has been halted.
Put UNIX into multiuser mode.
Depending on specific site requirements, this may be run-level
2, 3, 4 or 5. Enter:
init #
where # is the proper run-level to reboot UNIX in multiuser mode.
Log in to UNIX.
If a non-root user was specified in the pick0 configuration file during the installation, log in to this user, Creating a UNIX user account for D3
If the user root was specified in the pick0 configuration file during the installation, log in as root.