WWW-START starts the FlashConnect D3 servers. This command can be used several times to start connections in different server pools or to add connections to existing server pools. WWW-START can only be run from the FlashConnect master account.
Syntax
|
WWW-START #-connections web-server port {server-pool} |
Parameters
|
#-connections |
Number of FlashConnect phantoms started. One phantom and one D3 license is required for every concurrent FlashConnect session. |
|
web-server |
Name of the Web server servicing these connections. The Web server name can be an IP address, or server name which resolves through DNS. |
|
port |
TCP port number for the Web server that the FlashConnect service is listening on. |
|
server-pool |
Name of this set of FlashConnect servers. If this parameter is left blank, these servers are added to the pool of default servers. This parameter cannot be numeric only. It must consist of letters with or without numbers and cannot be greater than 14 characters in length. Correct name: "sales" and "sales1" Incorrect name: "123" |