The e command indicates the number of instructions to execute prior to returning to the BASIC/FlashBASIC debugger.
Syntax
e{number.lines} |
The e command, followed by pressing ENTER, disables the previous iteration counter setting and executes continuously.
Example(s)
Sets the execution counter.
*e10 |
Resumes program execution. This invokes the debugger after executing 10 lines.
*g |
Sets continuous execution.
*e |
Resumes program execution, cancels any previous e commands, and makes the program run without execution interruption. The g command must follow the e command to resume the program.
*g |