%bind() Function

The %bind() function binds a socket to a named resource. In case of a network, the resource would be an access point into the system (see the example below).

Syntax

code = %bind(fd, addr.family, address, port)

Parameter(s)

fd

File descriptor of the local socket returned by a previous call to the FlashBASIC C function %socket().

addr.family

Specifies the addressing scheme used by the protocol. This field must match the address family used when creating the socket. Valid values are defined in the include file: dm,bp,unix.h socket.h.

address

Legal values are defined in the include file: dm,bp,unix.h socket.h.

port

Port number on the local host. The legal value for this field depends on the protocol. On TCP/IP, for example, valid port number are from 1024 to 32767. This field may not be applicable for all protocols.

Description

To compile successfully, the statement cfunction socket.builtin must be included in the source code.

Upon successful completion, a value of 0 is returned in code. In case of an error, -1 is returned and the FlashBASIC system(0) function is set to the value of errno.

Example(s)

cfunction socket.builtin

include dm,bp,includes sysid.inc

include dm,bp,unix.h socket.h

* Create a socket

fd=%socket(af$inet, sock$stream, 0)

* Bind the socket to a local Ethernet port.

* Use default address.

if %bind(fd, af$inet, inaddr$any, 1024)<0 then

crt ’bind failed’; stop

end

* Wait for incoming connection

%listen(fd, 1)

* Accept a connection

address=0; port=0

fd=%accept(socket, &address, &port)

* Read data from the data link

%recv(fd, buffer, 1024)

See Also

%accept() Function

%gethostid() Function

%listen() Function

%read() Function

%socket() Function