- !shell command
The !shell command submits a shell command.
- ? command
The ? command displays help information. The UNIX file /usr/lib/pick/sdb.help displays using the pg command.
- ba command
The ba command adds a breakpoint.
- bd command
The bd command deletes the breakpoint.
- bl command
The bl command lists the monitor breakpoints.
- bo command
The bo command is the breakpoint offset. This command defines both the FID and the displacement, which are used in computing the effective address of a breakpoint in the ba command.
- d? command
The d? command displays or changes the default dump string.
- d command
The d command dumps the D3 core memory to the UNIX file /usr/tmp/ap.core. The result of the dump can be examined with the apcrash command. The d command can be used after an incident to dump selected elements of the current D3 memory to investigate the problem.
- e command
The e command toggles the debugger on or off. When off, prevents entry to the debugger by pressing BREAK. On line 0, the debugger is entered in some special cases even when the debugger is disabled.
- f command
The f command flushes memory. All frames modified in memory are written back to disk. If a disk error occurs, a minus sign displays.
- g command
The g command process resumes execution without any argument.
- gl command
The gl command displays or removes group locks.
- h command
The h command displays internal information about the specified FID if it is in memory, message <NIM> displays, or FID is not in memory.
- k command
The k command terminates the process associated with the PIB pib or the flusher, if used with the F key, by sending a SIGTERM to it. If used with the W key, the k command waits up to 10 seconds for the process to terminate. If it does not terminate, a SIGKILL is sent to it.
- l command
The l command displays, in hexadecimal, the link fields of the frame FID.
- m command
The m command displays or changes the real memory and the specified window at the real address.
- p command
The p command displays and changes the PIB. This command also displays the window bytes in the PIB specified by the PIB (that is, the current PIB if the PIB is omitted), at the optional offset.
- q command
The q command quits the monitor debugger.
- r command
The r command displays data through the register.
- S command
The S command scans the buffer table bits and displays and/or clears them depending on the certain criteria.
- s command
The s command displays or changes the semaphore status.
- t command
The t command sets and removes the monitor trace. A minus sign displays, acknowledging the removal.
- v command
The v command enters the Virtual Debugger with a specified code. If a code is not specified, enter the debugger as if pressing the BREAK key.
- x command
The x command displays hardware registers on the first line of the program counter, followed by a variable number of 32 bit registers.