Review the notes below before upgrading.
Upgrading is not supported from a pre-9.2 release. A full uninstall and install is required. If you are running any release prior to 9.2 (9.1.x or prior), please use the instructions in the Upgrading from version 9.1.2 or earlier topic in the D3 Windows Installation Guide to upgrade to D3 Windows 10.2.
If restoring from a release previous to 9.0, you must recompile your BASIC code if it was previously flash-compiled with the (o option. The (w option may be utilized if source code is not available.
If either of the D3VME or D3ODBC services are configured to log on as a specific account, you will need to re-enter and save that account's password in the Log On tab of the service's properties, then manually start or restart the service(s).
For more information on installing D3, see the Rocket website at:
Windows XP, Vista, Windows 2003 and any 32–bit version of Windows are no longer supported or certified platforms.
If you are using OpenDB and you are upgrading to D3 Windows 10.2, you must also upgrade to OpenDB 3.4.
All FlashBASIC code must be recompiled on D3 10.2 if coming from a release prior to 9.0. The compile.flash.all command allows automatic recompiling of all BASIC programs currently compiled with FlashBASIC, either in one or all accounts on the system. If the source code is not available, the programs can be compiled from the object code using the (ow compile option. The (w option is available for both the compile command and the compile.flash.all command.
If you are using FlashConnect and you are upgrading to D3 Windows 10.2, you must also upgrade to FlashConnect 3.9 with the FlashConnect 3.9.1 www account.