b/list command The b/list BASIC program formats and outputs BASIC source code listings. It can also be used to format a BASIC source program and write it back to the file from which it came.
basic command The basic BASIC program invokes the BASIC and/or FlashBASIC compiler, which translates the specified source code into executable object code with case-sensitivity in effect. This causes the compiler to only accept uppercase keywords.
basic-prot command The basic-prot command toggles or displays the status of the FlashBASIC object protection scheme.
bformat command The bformat command formats a BASIC source program and updates the source file with the formatted item.
blist command The blist command formats and outputs BASIC source code listings, according to the options chosen. It can also be used to format a BASIC source program and write it back to the file from which it came.
blkio command The blkio BASIC program displays or sets the I/O blocking factor, or number of frames read in one disk access during sequential file accesses. The setting is global for the whole system, and can be changed at any time.
block-print command The block-print command produces a banner by converting characters to a large block format, made up of rows and columns of the character itself.
bootstrap command The bootstrap BASIC program reloads the D3 operating system software from a currently executing system and then invokes the coldstart procedure.
break-key command The break-key command toggles the availability of the BREAK key, or displays its present status when issued without options. If the PIB number is specified, the BREAK key status displays or is modified for the PIB number requested.
break-key-off macro The break-key-off macro disables the BREAK key on the current port. If the PIB number is specified, the BREAK key is disabled on the requested PIB number.
break-key-on macro The break-key-on macro enables the BREAK key on the current port. If the PIB number is specified, the BREAK key is enabled on the requested port.
brk-debug command The brk-debug command indicates that the BREAK key invokes the debugger on subsequent uses.
brk-level command The brk-level command causes the BREAK key to push a level on subsequent uses. It is not possible to push a level while at the TCL prompt. At least one character must be entered.
buf-map command The buf-map BASIC program displays a visual map of the file system, indicating which frames are currently being held in the RAM buffer area, and updates the display every few seconds.
buffers command The buffers BASIC program displays a single snapshot of the status of memory-resident buffers. The loop (l) option repeats the display until voluntarily stopped.
buffers.g command Used in conjunction with the buffers BASIC program, the buffers.g command produces a graphic histogram of buffer usage for a range of dates and times.
bulletin.board command The bulletin.board BASIC program prints bulletins from the bulletin file located in the dm account.