Complete these instructions to install D3 with the selected settings.
Procedure
-
If not done previously, insert a scratch tape or floppy into each unused drive.
Drive detection takes place for the configuration file.
Note: Do not place a CD in the CD-ROM drive.
-
Select the Install D3 with current settings option from the D3
Installation menu.
You will see the tape devices currently installed, as shown in this example:
drive: /dev/fd0H1440 - 3.5 inch floppy added.
drive: /dev/fd0H720 - 3.5 inch floppy added.
SCT tape added. /dev/nst0
Linking monitor ...... completed.
-
When the installation completes, you will see the following message:
D3 Database Management System is installed
-
Remove all tape and floppy media that were inserted previously.
The D3 package is now installed. The system returns to the shell prompt.
-
Reboot UNIX from the shell prompt. Enter:
reboot
You will see the shutdown information.
-
If you are completing a new installation or an upgrade with a file-save tape, go to the
next section, Starting the D3 virtual machine .