Installing D3 with the chosen settings

Complete these instructions to install D3 with the chosen settings.

1. If not done previously, insert a scratch tape or floppy into each unused drive. Drive detection takes place for the configuration file.
   Note: Do not place a CD in the CD-ROM drive.
2. Select the Install D3 with current settings option from the D3 Installation menu.

   The system displays the tape devices currently installed as shown in this example.

   drive: /dev/fd0H1440 - 3.5 inch floppy added.
   drive: /dev/fd0H720 - 3.5 inch floppy added.
    SCT tape added. /dev/nst0
   Linking monitor ......   completed.

3. When the installation completes, the following message displays.

   D3 Database Management System is installed

4. Remove all tape and floppy media that were inserted previously.

   The D3 package is now installed. The system returns to the shell prompt.

   Note: In the case of an installation error, an error message should display. See Installation troubleshooting for more information.
5. Reboot UNIX from the shell prompt. Enter:

   reboot

   The system displays shutdown information.  

6. Proceed to the next section, Starting the D3 virtual machine .