The upgrade procedure described here is performed on an existing system using a backup file-save tape.
To upgrade, execute these instructions:
Perform a file-save.
Ensure that there is at least one complete file-save of the system (preferably two) prior to starting the upgrade, and verify the save tape with the t-verify or appropriate command.
A file-save tape does not back up spooler hold files. To back up the spooler hold files, use sp-edit (cv to turn them into items in a data file, which can be saved to the file-save tape. See the sp-edit Command topic in the D3 Reference Manual for additional information.
Review Getting Started:
Complete the worksheet.
Review Upgrade Issues.
|
NOTE |
If migrating to D3 from another D3 platform, Advanced Pick, R83 or another Pick compatible environment, see Migration Tips. |
Shut down D3. Enter:
|
shutdown |
Proceed with the upgrade:
Proceed to Installing D3, and complete those instructions.
After completing the instructions, return to this section and proceed with the next numbered instruction.
Complete the upgrade process by executing the instructions from the dm account in the following sections:
|
NOTE |
The default statement to boot D3 is d3 -0. Although the ap command is currently supported, the pick command is not. Replace the ap and pick commands with the d3 command, as future releases of D3 may not support ap. If the commands pick -{port} or ap -{port} are included in the inittab file (/etc/inittab), change them to the new syntax. |
See Also