You can choose to make the power pads dockable. When the Enable
Docking check box is selected, you can drag one or more power pads into the BlueZone
session window and dock them. Power pads can be docked to the top, sides, or bottom of the inside
of the BlueZone session window. Power pads can also be stacked on top of one another. You can
stack up to sixteen power pads in the same location. When docking, if the power pad is very tall,
you will only be able to dock it to the left or right side. If the power pad is very wide, you
will only be able to dock it to the top or bottom. After the power pad is docked, if the power
pad is large, you may have to adjust the size of the BlueZone Session window to display the whole
power pad.
To drag a power pad, point to the title bar with your left
mouse button. Then, while holding down the left mouse button, drag
it to the desired spot within the BlueZone Session window. You will
see the outline of the power pad change, and the title bar disappear,
when it is in a "dockable" position.
Note: Closing a power pad, by clicking the power pad's X,
during a BlueZone session will not remove it from the Active
Power Pads list. This only temporarily closes the power
pad.