Enabling registry mode
The BlueZone setup program uses values in the SETUP.INI file to set parameters during installation. By default, registry mode is not enabled. To enable registry mode, you must
edit the SETUP.INI file and change the ProfileMode= setting to No.
Note
You cannot run the BlueZone
SETUP.EXE program from the BlueZone CD-ROM if you want to install BlueZone in registry mode. You must copy the BlueZone installation
files to your hard drive so that you can modify the
SETUP.INI file.
|
1. |
Copy the entire BlueZone Desktop folder from the BlueZone CD-ROM to a convenient location on your workstation's hard drive. |
|
2. |
Open the SETUP.INI file with a text editor. |
|
3. |
Locate the [BZSetup] section, and change the ProfileMode=Yes setting to ProfileMode=No. |
|
4. |
Save and close the file. |
|
5. |
In the same folder on your hard drive where the modified SETUP.INI file is located, double-click SETUP.EXE to install BlueZone. BlueZone is now installed in registry mode.
|