Connection tab

Communications Library

BlueZone displays the available host connection options. Select the appropriate link for additional configuration information:

Note

BlueZone defaults to the Connection Type that was select during installation.

Connection Type

•

Renex Async Protocol: Select to connect to the host system using a Renex TMS or RPad Communications Controller.

•

TN5250/TN5250E: Select to connect to the host system via TCP/IP using the TN5250/TN5250E protocol.

Configure

To configure a connection, highlight a connection type in the Connection Type list and click Configure. The TN5250E Properties Dialog appears.

Note

The other connection types that appear in this Connection Type list are non-operative.

Options

After selecting the Connection Type, select from the following options:

•

Auto-Connect Session: If checked, BlueZone auto-connects the active session whenever it is launched.

•

Auto-Reconnect if LU is Deactivated by Host: If checked, BlueZone auto-connects the session if the device being used is varied off on the host system while a BlueZone session is active.

•

Connect Retry: If checked, BlueZone tries to connect to the host the number of times selected in the Retry up to drop-down box and use the interval selected in the times, retrying every drop-down box.

Note

The device obtained by the re-connect may not be the same as with the prior session.