Wizard How To Guide

BlueZone Web-to-Host

How to Enable FIPS Support

Enabling FIPS Mode - Click here to learn more about this feature

By default, FIPS Mode is not enabled.  To enable FIPS Mode, you will have to edit the default.ini file using Notepad.

Follow the procedure below.

This is a Global Level Feature.

Procedure

  1. On the web server where BlueZone Web-to-Host is installed, locate the following path:

C:\Inetpub\wwwroot\bzw2h

 

  1. Locate any Launch Folders that you may have created.

For example, if you created a Launch Page called "TEST", you will see a folder called \TEST as shown here:

C:\Inetpub\wwwroot\bzw2h\TEST\

 

  1. Go into each Launch Folder and locate the default.ini file.

  2. Using Notepad, edit the default.ini file and locate the [BlueZone] section.  The [BlueZone] section will have many entries.  The FIPSMode entry should be at or near the bottom of the [BlueZone] section as shown here:

[BlueZone]

FIPSMode=No

 

  1. Change FIPSMode=No to FIPSMode=Yes

  2. Save the file.

  3. Repeat this process for all the default.ini files located in all the Launch Folders where you wish this change to apply.  You can mix and match.  You could have some Launch Pages with this feature off and others with it on.

NOTE  If you edit the default.ini file located in the "Template" folder, you will not have to edit any new Launch Folders you create in the future.  The files located in the "Template" folder are the master files that are used by the Web-to-Host Wizard.

Related Topics:

How To Lock BlueZone Emulator Features

How To Lock BlueZone FTP Features