Connection tab

Communications Library

Rocket TE displays the available host connection options.

Connection Type:

Unisys DCA: Select to connect to the host system using the Unisys DCA protocol.

Note: Unisys DCA is currently the only available connection type.
Properties: Click to configure the Unisys DCA connection type. Refer to Configuring the UTS terminal settings for more information.

Options

After selecting the Connection Type, select from the following options:

Auto-Connect Session: If checked, Rocket TE will auto-connect the active session whenever it is launched.
Auto-Reconnect session (when Deactivated by Host) in: If enabled then Rocket TE will auto-connect the session if the Device being used is varied off on the host system while a Rocket TE session is active in the number of seconds specified in the list box. 0 through 10 seconds can be selected.
Auto-Close Session on Disconnect: If checked, the Rocket TE application will auto-close after disconnecting from the host system.
Connect Retry: If checked, Rocket TE will try to connect to the host the number of times selected in the Retry up to list box and use the interval selected in the times, retrying every list box.